User guide

SEEDHAWK®30SERIESOPERATOR’SMANUAL35
4.7 PREPARATIONBEFOREFILLINGTHESEEDHOPPER 
Normally the front seed hopper is used for seed and the rear hopper for fertilizer.It is also
possibleto usebothhoppersforseed.In thatcasethe positionof aflap must bechanged so
thatthehopperthatnormallyfeedsoutfertilizerwillnowfeed outseedtotheseeddistributor
head.NotethatthisalsorequirestheLOUPIIImonitortobereprogrammed.

CHECKBEFOREFILLING:

1.Thatthemachineisempty,cleananddry.

2.Thatthelevelguardsareadjustedcorrectly;REFERTO“4.7.1SETTINGTHELEVELGUARDS”.

3.Whichrotorandgearare
bestsuited,SEE“11.0SEEDINGTABLE”ONPAGES123&124and
then make the settings in accordance with “4.11 REPLACEMENT ” ON PAGE 40 AND “4.12
GEARINGUPANDDOWN”ONPAGE42.

4.That the emptying hatches are closed, SEE “4.10  OPENING THE EMPTYING
HATCH/EMPTYINGTHESEEDBOXONPAGE 39.

4.7.1 SETTINGTHELEVELGUARDS
Theheightsof thelevelguards can beadjusted.Thesensors(A) can bemoved todifferent
cutoutsintheirbrackets.
1.The6upperpositionsareusedforcornseed.
2.Thelowerpositionisusedforoilseedandothersmallsizeseeds.


















FIGURE4.6 