Instruction Manual

SEED HAWK

2015 30 SERIES OPERATOR’S MANUAL – DOMESTIC 31

4. Fit the locking pin in position (C) for low gear and position (D) for high gear.

1. Remove the rotor. Refer to Section 4.9 on rotor replacement.

4.11 Seed Control

4.11.1 Installation & Removal of Seed Control

Plate

Seed control can be used in extreme conditions if certain seed types are press-

ing too hard against the rotor causing uneven operation.

NOTE: When sowing slow-moving seeds, such as grass seed or clover and

grass mixes, seed control must never be installed, as the seed can otherwise be-

come compacted against the seed control plate and, in the worst case scenario,

stop the ow.

2. Remove the cover (A) by rst undoing the knob (B).

Slow (C)

Fast (D)