User's Manual

1. How to Use
Wearing the Headset
You can put on the VSH-511 either on your left or right ear.
To change ear, pull the ear hook down to the other side and turn it over the ear speaker.
And, extend the ear hook then slip it over the top of your ear, manoeuvre the speaker
gently into your ear, make fit the headset until it is held securely on your ear.
Charging
Before using your VSH-511, you need to charge it fully by plugging the charger into the DC
jack outlet. Charge the Headset for approximately 2 hours until the indicator lights go out.
Tip) Low Battery Warning
Recharge the headset when you hear a short beep at 7 second intervals. You have 5 to 7
minutes of talk time remaining once this warning indicators start.
Power On
Press and hold the Power/Talk button for more than 1 second.
Power Off
Press and hold the Power/Talk button for more than 4 seconds.
Bluetooth Pairing
1. Turn the VSH-511 on, then press and hold the Power/Talk button for at least 5
seconds until you hear a series of beeps followed by a connection signal. The blue
LED indicator light begins to flash once every second.
2. Follow the instruction guide for your phone. This usually involves going to a “setup”,
“connect”, or “Bluetooth” menu on your handset and then selecting the option to
“discover” or “add” a Bluetooth device.
3. When requested the passkey or PIN⁴, press “0000” (4 zeros). You will receive
confirmation when pairing is complete. If pairing is unsuccessful, repeat these
steps.
If pairing is successful, the blue LED indicator light will flash in standby mode every
5 seconds. If pairing fails, this will flash once every second. Please repeat the
above steps.
NOTE)

Pairing can be done with up to 3 Handsets maximum, if you add a 4th Handset,
the VSH-511 will automatically remove the registration information of the least
used

VSH-511 can be only in pairing mode when the headset turned off.
Answering a call
Press the Power/Talk button.