Bluetooth CarKit SEEFreeKit User's Manual SEECODE Co., Ltd. 3rd Floor, amin Bldg., 110-1, Yangjae-dong, Seocho-gu, Seoul 137-891, Korea http://www.seecode.
Features - Superior noise suppression - Excellent echo cancellation - Superior full duplex - Digital volume control - Microphone / Speaker mute - Easy installation - Quick connection to Bluetooth - Pairable up to 3 Bluetooth - Support for the Bluetooth phone phone Headset profile Specifications - Rated input voltage : 12Vdc - Operating voltage : 12V - 24V - Operating current : 30mA - 250mA - Speaker output power : max 1 Watt - Operating temperature : -10 to 60 How to install Just insert CarKit to Cigar
Part Description - Volume Up : Used for volume up - Volume Down : Used for volume down - Send : Used for calling, Answering, Voice call, Audio transfer, etc.
red phone by pressing SEND button or by using phone's bluetooth connect function. Otherwise (there is no device registered in the Carkit's phone data base) it will operate in the Pairable mode - in which mode you can register the phone into the CarKit's phone database. (See LED indication section fo r additional information) Power Off 1. When car's operation is off or pulling out the CarKit from the cigar jack the power will become down automatically. Pairing 1, Press END button for more than 5 secs. 2.
- Register using a Ericsson phone : Connect → Bluetooth → Extras → Bluetooth → Add devices → Phone initiate → Headset → The display reads 'SEEFreeKit 1.0' → Add to d evices → Type "0000" → You can read "Pairing succeeded" Establishing connection between CarKit and Mobile phone If you want to establish a connection between the Carkit and the mobile phone, when there is no connection, you could do the following : 1. Press SEND button for less than one second 2.
Volume Up / Down 1. Adjust volume with the buttons located on the side of the CarKit. 2. If you press the Volume Up or Down button for a while, volume will be c hanged continuously at the interval of 0.2 second. 3. There are 8 volume levels. LED Indications State Red LED Waiting for connection Don't care Connecting (initiated by Carki Don't care t) Connected Don't care Active call exists Don't care Blue LED Blink Blink Blinking interval Blinks once per 5 sec Blinks once pre 0.
Notice : The changes or modifications not expressly approved by the party responsible for compl iance could void the user’s authority to operate the equipment. IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate th e device.