User Manual

Care & use/ FIre PIT InsTallaTIon

LIGHTING INSTRUCTIONS

STEP 1: Make sure the gas shut-off valve on the LP Tank is in the open position

STEP 2: Start the spark igniter by pressing the ignition button. The starter will stay on until the button is pressed again.

STEP 3: Using the Gas Valve Key, open the gas burner control

valve through the opening in the control panel. Turn the key to the

left (counter-clockwise) until it is full open. The burner should light

immediately. If the burner does not light in 4 seconds, turn the gas valve

OFF, push the ignition button to turn off the igniter, Wait 5-minutes for

any gas to dissipate, then repeat steps 2 and 3 again. If the burner fails

to light contact Lynx Customer Care.

STEP 4: After the burner lights push in the ignition button to shut off

the ignition module.

STEP 5: Use the gas valve key to adjust the ﬂame to a comfortable level.

DO NOT LEAVE A LIT FIRE-PIT UNATTENDED!

Shutting Down the Fire Pit

STEP 1: Using the Gas Valve Key Turn off the gas to the burner by turning the Key to the right (clockwise) until the

valve is fully closed

STEP 2: Shut OFF the LP tank gas valve

Converting to a Beverage Holder

You new Lynx Fire Pit is easily converted into an icy beverage holder for those warm days when a ﬁre pit Is not needed.

STEP 1: Shut off gas from the LP Cylinder and remove the LP Hose

STEP 2: Disconnect the ignition wire at the connector

STEP 3: Lift out the burner pan using the convenient handle

STEP 4: Insert the Ice pan into the cutout opening

STEP 5: Fill with ice and your favorite beverages and enjoy.

Trouble ShooTing

1. Make sure a fresh 9 volt battery has been installed

2. Make sure all wire connectors are ﬁrmly attached. They may have come loose in shipping

3. Check to see that the LP tank is full and properly connected.

If you have any problems or concerns, please contact Lynx Customer care

Lynx Grills, Inc.

7300 Flores Street

Downey, CA 90242

888-289-5969