User Manual

8
|
Care & use/ FIre PIT InsTallaTIon
INSTALLING THE LP CYLINDER...continued
The LP tank is brought into the fire pit enclosure and
secured to the square base frame by the bottom ring of
the cylinder.
Connect the LP hose and regulator assembly to the LP
Cylinder. Do not use tools when making this connection,
the knob must be hand tightened only.
Rotate the burner pan until the gas valve lines up with
the opening for the gas valve key. Make sure the burner
control valve is in the OFF position before opening the
cylinder valve.
STEP 1
STEP 2
Safety PrecautionS
Inspect the LP gas hose and connections before each use. If there is any damage from normal operating conditions,
weather, rodents or other adverse conditions do not use the hose. Turn OFF the LP tank valve and replace the hose and
regulator assembly. Replacement parts are available from the Lynx Grills, Inc..
Before using your fire pit you must test all gas connections to ensure leak-free connections. Gas connections can be
tested with a solution of 1 part dish soap to 3 parts water. Turn on gas at the cylinder gas valve. Brush or spray the solu-
tion on all connections and look for the formation of bubbles. NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
If you find any leaks, tighten the connections and retest. If you cannot stop the leak, turn off the gas at the cylinder gas
valve and call a qualified repair technician, or contact Lynx Grills to arrange a service call.
Inspect the burner assembly regularly for damage. Clean any blocked ports. Be aware that insects like to make webs
inside burner assemblies and hoses.
LP Tank Bottom Collar
Support
Line up gas valve with
key control opening