User Manual

6
|
Care & use/ FIre PIT InsTallaTIon
STEP 1: Unpack the table top and the base. Remove all packing materials, tie down straps and any other packaging.
STEP 2: Place the fire pit base on a flat firm surface. The Fire Pit must be on solid ground or pavers so it will not sink over time.
STEP 3: With the help of an assistant, place the table top on top of the base, making sure the table top is centered properly.
SEDONA FIRE PIT ASSEMbLY INSTRUCTIONS
Burner and IgnItIon Controls
Install burner and burner pan in the table top opening. This can be accomplished In one or two ways.
Before dropping the burner pan into the enclosure, connect the LP hose to the LP cylinder, and the ignition wire from
the igniter module to the power button.
As an alternative you can install the burner pan into the table top, and working from the base access door, connect the
LP hose to the LP Tank, connect igniter module to the power button.
Do not add the burner media until you check the spark ignition in the next step.
Ignition Wire Connector
STEP 1
9 volt battery