MAKE THE MOST OF YOUR SEDONA TM BY CARE & USE/ICE ‘N FIRE PIT INSTALLATION Warning: Improper installation, adjustment, alteration. Service or maintenance can cause severe injury or death, and may result in property damage. Read these installation, operating and maintenance instructions thoroughly before installing or servicing this appliance. INSTALLER: THIS MANUAL MUST BE LEFT WITH THE APPLIANCE. CONSUMER: KEEP THIS MANUAL FOR FUTURE USE.
WARNINGS SEDONA WARNING READ THIS MANUAL CAREFULLY and completely before using your outdoor appliance to reduce the risk of: 1. Fire 2. Burn hazard, personal injury or property damage 3. Unapproved installation or servicing. This product is designed for outdoor use only. Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death. Read this manual thoroughly before installation, use, or servicing of this product.
WARNINGS WARNING • Never use dented, rusty or damaged propane cylinders. Never store additional or empty propane cylinders in the cabinet or in the vicinity of this or any other appliance. Do not store propane cylinders indoors or on their sides. • Children should NEVER BE LEFT ALONE or unattended in an area where an appliance is located. Place your appliance well away from areas where children play.
WARNINGS SEDONA WARNING 1. This outdoor appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.5 kPa). 2. This outdoor appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa). STATE OF MASSACHUSETTS 1.
IMPORTANT SAFETY PRECAUTIONS PLEASE REVIEW THESE IMPORTANT SAFETY PRECAUTIONS BEFORE YOU USE YOUR FIRE PIT. 1. NEVER LEAVE THE FIRE PIT UNATTENDED WHILE IN USE. 2. Follow the instructions in this manual carefully to reduce the risk or personal injury, death or property loss. 3. Ensure all tie-down wires have been removed from the burners. 4. Always use caution when operating the appliance in a windy area. 5. Avoid wearing loose-fitting garments or long sleeves while adjusting fire pit media.
SEDONA Fire Pit Assembly Instructions STEP 1: Unpack the table top and the base. Remove all packing materials, tie down straps and any other packaging. STEP 2: Place the fire pit base on a flat firm surface. The Fire Pit must be on solid ground or pavers so it will not sink over time. STEP 3: With the help of an assistant, place the table top on top of the base, making sure the table top is centered properly. Burner and Ignition Controls STEP 1 Install burner and burner pan in the table top opening.
Burner and Ignition Controls ...continued STEP 2 Press the ignition button and verify a spark is present at the spark electrode at the burner assembly. If you do not see or hear a spark, please refer to the trouble shooting section of this manual. If the ignition spark is present, proceed to the next step, addition of burner media. Media Installation Your Ice ‘N Fire Pit needs burner media in order to create realistic, natural looking flame effects.
Installing the LP Cylinder...continued STEP 1 LP Tank Bottom Collar Support Line up gas valve with key control opening The LP tank is brought into the fire pit enclosure and secured to the square base frame by the bottom ring of the cylinder. STEP 2 Connect the LP hose and regulator assembly to the LP Cylinder. Do not use tools when making this connection, the knob must be hand tightened only. Rotate the burner pan until the gas valve lines up with the opening for the gas valve key.
Lighting instructions STEP 1: Make sure the gas shut-off valve on the LP Tank is in the open position STEP 2: Start the spark igniter by pressing the ignition button. The starter will stay on until the button is pressed again. STEP 3: Using the Gas Valve Key, open the gas burner control valve through the opening in the control panel. Turn the key to the left (counter-clockwise) until it is full open. The burner should light immediately.
REFRESHMENT BOWL CONVERSION 1. Remove gravel pan from top 2. Place refreshment bowl into top 3. Refreshment bowl FEATURES Model No. LFPC-S & LFPC-G. 44” round top on round pedestal with unique nautilus burner. LFPS-S & LFPS-G 44” square top on round pedestal with unique nautilus burner. Tumbled volcanic variegated stone. Access door provides easy accessibility to LP Tank and battery compartment. PERFORMANCE 65,000 BTU max. TECHNICAL Fuel Type: LP Standard / NG Kit available.
6 3 5 12 25 15 2 1 4 9 8 10 16 13 14 11 ITEM 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 PART No. 80884 34641 34640 31217 34654 34644 34652 31162 70231 34773 34774 34775 31582 34695 14030 31876 33706 32768 80661 70230 13012 13054 30751 70232 80883 DESCRIPTION FIREPAN WELDMENT NAUTILUS BURNER IGNITER SHIELD SPARK ELECTRODE, 15" BRACKET, BURNER RETAINER HANDLE, PAN KEY VALVE, FIREPIT IGNITOR, 2 SPARK BATTERY HOLDER MOLEX PLUG, PANEL MOUNT LOCK NUT, ELECT.
| Care & use/ FIRE PIT installation
SEDONA BY LYNX ICE N’ FIRE PIT LIMITED WARRANTY I. Limited Twelve-Year Warranty. The Nautilus stainless steel main burner carries a limited twelve (12) year warranty. This warranty excludes surface corrosion, scratches, and discoloration which may occur during normal use. This warranty is limited to the replacement of the defective parts, with the owner paying all other cost including labor, shipping and handling. II. Limited Five-Year Warranty.
Lynx Grills 7300 Flores Street Downey, CA 90242 Service: (888) Buy-Lynx (888-289-5969) Fax: (562) 299-6978 www.lynxgrills.
