Specifications
2
Sedna Line Interactive UPS
3
Sedna Line Interactive UPS
UPS
4
2
1
2
3
1
3
5
5
5
2
1
2
5
1
4
IEC Type
Schuko Type I
Schuko Type II
South Africa Type Universal Type
2
Output receptacles
AC input
Circuit breaker
Optional USB & RJ-11 combinations
Optional network
surge protection
1
2
3
4
5
USB & RJ-11 combinations:
RJ-11 port
USB port
3
Installation & Initial Startup
NOTE: Before installation, please inspect the unit. Be sure that nothing
inside the package is damaged.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate air ow. Please place the UPS
away from other units at least 20 cm to avoid interference. Do NOT operate the UPS where the temperature and
humidity is outside the specic limits. (Please check the specs for the limitations.)
Connect to Utility and Charging
Plug in the AC input cord to the wall outlet. For the best
results, suggest to charge the battery at least 4 hours
before initial use. The unit charges its battery while
4 hour s
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn on the power
switch of UPS unit, then devices connected to the UPS will be protected by UPS unit.
CAUTION:
NEVER connect a laser printer or scanner to
the UPS unit. This may cause the damage of
the unit.
Connect Modem/Phone/Network for Surge Protection
(Only for the model with RJ-11/RJ-45)
Connect a single modem/phone line into surge-protected “IN” outlet on the back panel of the UPS unit. Connect
from “OUT” outlet to the computer with another phone line cable.
Connect Communication Cable (Only for the model with USB/RS-232 port)
To allow for unattended UPS shutdown/start-up and status monitoring, connect the communication cable one
end to the USB/RS-232 port and the other to the communication port of your PC. With the monitoring software
installed, you can schedule UPS shutdown/start-up and monitor UPS status through PC.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the power switch.
Cold Start Function
When the UPS is off and there is no power utility, it’s still possible to cold start the UPS unit to power the loads.