Installation manual

INSTALLATION MANUAL AND USERS GUIDE
Multi Split Series – Ductless Split System Heatpump
04006020101 © Sedna Aire Europe 9 12/2012
Emergency operation:
When the remote control was lost or is damaged, emergency
operation can be carried out as following:
Open the cover front surface lit and you will see two handling
switches. The manual switch is labeled AUTO/STOP, the other
code switch differentiates between four different modes
 Manual switch: Press to switch between Auto mode
and Off. In the Auto mode the unit will run and set the
appropriate heating or cooling mode depending on set
temperatures and current measured room
temperature.
 Code switch: Move the lever to Auto and the unit
starts the Auto mode as described above. Move it to
Stop and the units shuts off. TEST and RUN are only
for service personnel during installation.
6. CARE AND MAINTENANCE
CAUTION
 Turn off power and pull out the power plug before cleaning the air
conditioner.
 Never spray or sprinkle water on the indoor unit for cleaning. You may
get an electrical shock which could kill you
 Volatile liquids /e.g. thinner or gasolines) will damage the air
conditioner. So wipe the units with a dry soft cloth or slightly
moistened with water or cleanser.
Clean the front panel
When the indoor unit front panel is dirty, please use a cloth which is slightly moistened with warm
water/cleanser under 40 °C, then dry it and wipe off the dirty spots.
NOTE:
The indoor units contains microcomputer components and circuit board in the display which are very
sensitive against water. So don’t put any water into the interior of the indoor unit.
Manual
switch
Code
switch