Installation manual
INSTALLATION MANUAL AND USERS GUIDE
Multi Split Series – Ductless Split System Heatpump
04006020101 © Sedna Aire Europe 8 12/2012
Note:
In the AUTO mode the unit will automatically adjust its running mode according to the
room
temperature
.
SPECIAL FUNCTIONS
Dehumidifying (only in cooling mode)
Moisture in the indoor unit will be removed after the unit has stopped. This is intended to avoid
mildew in the indoor unit.
When having set X-FAN on: After turning off the unit (On/Off button), the fan in the indoor
unit will continue for further 10 min. If you want to stop that too, press X-FAN again.
When having set X-FAN off: After turning off the unit (On/Off button), the unit will stop at
once.
Auto Run
In the AUTO mode the unit will automatically adjust its running mode according to the
room
temperature
. The preset temperature will not be displayed.
Defrost:
When the outdoor temperature is low but the humidity is high, the heat exchanger of outdoor
unit may be frosted after the air conditioner has run for a period of time. This will decrease the
heating effect. To set this mode on, switch unit off. Press Mode and X-Fan buttons
simultaneously for switching on or off and store it to the control. If the unit is under defrost
mode, H1 will appear instead of a shown temperature. If you choose heating, the H1 will
appear and flicker for 5s. Press + or - and H1 will disappear and the preset temperature show
up.
Both the indoor fan and outdoor fan will be stopped during auto defrost.
During defrost, steam might flow from the indoor unit.
The defrosting is carried out until it is completed. All other programs are stacked and will
resume upon completion of the defrost process.
Dew at the air outlet:
lf the unit runs for a longer time in the cooling mode together with an ambient relative
humidity higher than 80% (door and windows are open), dew might drop out near the air
outlet.
Refrigerant recovery (only CMO36/42)
Power indoor and outdoor units on. Set COOL mode. Press within five minutes (after
having turned on the unit) the “LIGHT” button 3 times in 3 seconds. The display will show
“F0”. Quit the recovery by sending any other signal from the remote control to the indoor
unit or when the recovery has elapsed 10 minutes.