Installation manual
INSTALLATION MANUAL AND USERS GUIDE
Multi Split Series – Ductless Split System Heatpump
04006020101 © Sedna Aire Europe 7 12/2012
4. BATTERY CHANGE
1 Press lid and remove it
2 Take old batteries out
(2 AAA dry cells)
3 Insert new batteries
(2 AAA dry cells)
4 Insert lid again
NOTE
Don’t mix new and used batteries
Remove batteries when unit is not be used for a longer time
The batteries hold for appx. one year under usual conditions
The remote control should be 1 m away from television or audio device, since it could
interact under unfavorable conditions with them
Displace batteries correctly. They are not standard household waste.
USER NOTES
The entire capacity of the indoor unit shall not exceed the capacity of the outdoor unit by
150% over a longer time. Otherwise it will reduce the overall capacity
A breaker(Fuse) needs to be installed for each indoor unit and the capacity has to be
according to the indoor unit’s electrical parameters. All indoor units are required to be
centrally controlled by one switch, which enables to cut off electrical power in case of an
emergency. The breakers act as short circuit prevention and to avoid abnormal overloads
The main switch must be accessible easily and at all times
Switch of power before cleaning and maintenance of the indoor units
After having turned off the indoor units, they will continue to work for 20-70 sec. to deplete
the residual cool/heat in the unit’s evaporator, while preparing for next operation. This is
normal
When the selected mode for the indoor unit does not correspond to the mode of the outdoor
unit, the malfunction light will blink on the indoor unit or remote control. Change the
operation mode or the indoor unit will stop after 5 sec without entry. The cooling mode is
compatible with the Dry mode and the Fan mode is compatible with all modes.
5. HOW TO OPERATE THE UNIT
1 Connect the unit with power and set eventual breaker on. The unit starts. Note: When unit is
powered off, the guide louver of the indoor unit will close
2 When you press the ON/OFF button, the Power/Run indicator switches over to green and
shows the running mode (Cool, Heat, Auto). The air conditioner starts now to run.
3 Press the MODE button to switch between the various running modes.
4 Press the SWING button to start or stop the automatic swing mode of the indoor units
5 Press the FAN button to set the desired fan speed.
6 Press the + or - button to set the desired room temperature.
7 Press the SLEEP button to set the unit to sleep
8 Press the TIMER button to set a predefined start and Stop time, for example when you are
not around and want to get it started half an hour before you return
9 Press + and - simultaneously and you may lock or unlock the remote control. A lock sign
appears in the display
10 Switch unit off. Then press Mode and - simultaneously and you may switch between °F or °C