Installation manual

INSTALLATION MANUAL AND USERS GUIDE

Multi Split Series – Ductless Split System Heatpump

04006020101 © Sedna Aire Europe 13 12/2012

8. LOCATION OF INSTALLATION

Choose a proper location for the indoor and outdoor unit

Indoor unit

 The intake and outlet should not be covered, so that the outflowing air can reach all the parts

of the room

 Install in a location, from where the condensation water can be drained easily out and that

allows a short and easy connection to the outdoor unit

 Avoid close heat sources, steam or flammable gas

 Choose a location which is strong enough to withstand the weight and vibration of the unit

 Allow enough clearance space to have access for routine maintenance e.g. replacing the

filters .

 The height of the installation should be min. 2,2 m above the floor.

 Wall unit: Stay away 15 cm from the ceiling (measured from air intake to ceiling), 15 cm on the

left and right side of the unit to any walls.

 Cassette: Install cassette in middle of the room to allow optimal air distribution into all corners

 Stay away at least 1m from other electric appliances like TV, audio devices etc.

 Do not locate the indoor unit in the immediate proximity of a laundry, bath, shower, or

swimming pool.

 Make sure you can access the plug after having installed the indoor unit.

Outdoor unit

 Choose a locations that minimizes noise and airflow to the neighbors.

 Select a location which allows enough ventilation for the fan of the outdoor unit.

 Do not cover intake and outlet of the air of the condenser.

 Choose a location which is strong enough to withstand the full weight and vibration of the

outdoor unit and permits safe installation.

 Avoid any proximity to hazardous and flammable gases, liquids.

 When handling the outdoor unit, keep it always upright. Handling must be done by qualified

people being able to handle heavy loads.

 After having opened packaging, make sure that all equipment are undamaged and all parts at

right and available.

 Make sure that clearance requirements are met. (As seen from the front):

 Left side: min. 30 cm to any wall

 Right side: min. 50 cm to any wall

 Top: min. 50 cm to any cover

 Front: min. 200 cm to any wall or greater obstacle

 Back: min. 30 cm to any wall