Installation manual

INSTALLATION MANUAL AND USERS GUIDE
Multi Split Series – Ductless Split System Heatpump
04006020101 © Sedna Aire Europe 10 12/2012
Clean the air filters in the indoor unit (all 3 months recommended)
Take out the air filters:
Open the surface panel, hold the tab of the air filter and
raise it slightly. Then tale it out along the direction of the
arrows (see right figure)
Clean the filter
 Use a vacuum cleaner for removing the dust from the
filter or
 Wash them with water and a mild cleanser and dry
them in the shade (no full sun exposure)
NOTE: Never use water above 45°C to wash filter. This can
cause deformation or discoloration. Never parch it by fire,
since this could cause a fire or deformation.
Reinsert the filter
Reinsert the filter along the direction of the arrow, then
cover the surface panel and clasp it
Maintenance of outdoor unit
 Turn power off
 Clear dust from outdoor unit
 Repaint the rubiginous place on the outdoor unit to prevent it from spreading
Check before you use the unit
 Be sure that nothing obstructs the air outlet and intake vents
 Check that the unit is „earthened“, i.e. that the earth wire from the unit is connected with the
ground/earth of your power supply in the house.
 Check whether the batteries in your remote control or still operational
 Check if the outdoor unit is standing firm on its base or rack. If not, contact your service center.