Specifications

Configuration

How to Use the Keypad to Program the MR-2320

1. Press (Menu button). You will be prompted to enter your password.

2. Enter your password, then press (Enter button) to continue.

3. Select a Command Menu option by pressing . The corresponding submenu will display.

4. Use the up and down arrow buttons to scroll through the submenu.

5. Press to select a submenu option.

6. Use the left or right arrow buttons to select/unselect an option (selected = “X

”). Use the up and down arrows to

scroll through the different menu options. When entering numerical data, use the up and down arrows to

increase or decrease the number.

7. Once you have made the correct selection, press to confirm the change. The display will return to the

submenu screen.

8. Press (Cancel button) to return to the previous menu.

Command Menu

The main command menu is pictured below. The first line of the LCD will always show “-Command Menu-“, and the

second line scrolls through different selections. Use the “UP” and “DOWN” keys to scroll through the menu, and

press the key to make a selection. To exit from the main command menu, select the “Exit” menu option and

then press either the or key.

Pressing “LAMP TEST” at any time will

show the information about the system and

the software version as shown below.

The first line shows the panel mode number,

pre-programmed mode and the information

if the panel has a dialer or not. The second

line shows the software version number. The

version of the software is read as

Major.Minor.Revision.

Note: Command Menu Item 1 and 6 can only be accessed if jumper JW6 is placed on the main board.

-Command Menu-

1. Panel Config

2. Set Time

3. Set Password

4. View EventLog

5. Clear Event Log

6. Dialer Config

7. Test Dialer

8. Exit

Access level Required

Configuration

Command

Configuration

Command

AR Mode1 DACT

Version 1.0.16