Specifications

MR-2320 Series Installation and Operation Manual
33
Entering the Passcode
The programming section is passcode protected. The following screen shows the message that is displayed to
enter the passcode. The maximum allowable passcode is ten digits long, and permits numerical values only. Press
(Enter button) after entering the passcode. If the passcode is correct, it will take you to the main command
menu. If the passcode is wrong the system will ask you to re-enter passcode. The system will be exhausted after
three retries and will then take you back to the Normal message display.
Three leves of access are defined:
1) Command - Level 0:
The default password is for this level “1111” without quotes. In this level the user can only perform regular
testing and operation.
2) Configuration - Level 1:
The default password is for this level “2222” without quotes. User can change configuration and have
access to command level.
3) Factory - Level 2:
Currently not used.
When the user presses “MENU” and enters the passsword, they should enter the password of the level intended. If
the user is in a lower level of access, attempts to operate functions requiring a higher level of access will be refused.
Enter passcode:
_