Specifications

MR-2320 Series Installation and Operation Manual
7
Mechanical Installation
Installing the Enclosure
Install the MR-2320 Series panel enclosure as shown below. Mount enclosure surface mount using the four
mounting holes with the provided screws.
Figure 1: Box dimensions, semi-flush mounting and trim ring
Remove the door (also disconnect the ground strap), the dead front and semi-flush mount the backbox into the wall.
Peel the adhesive cover from the trim ring and stick to the wall surface around the backbox, after wall is finished.
17"
22.5"
Adhere trim ring to
wall surface around
the MR-2320 backbox.
PLACE MR-2320 TRIM RING OVER BACKBOX
14.5"
4
.
5
"
11"
20.0"
1.5"
5.425"
14.5"
3.5"
1"
3.5" is the maximum depth
for semi-flush mounting
using the flush trim ring
1" is the minimum depth
above the wall required
for semi-flush mounting
using the flush trim ring
4 Mounting
Holes for
Surface
Mounting