User guide

MR-2100/2200 Programming Manual
60
7.0 Appendix D: Table of Reporting Codes
The following tables contain automatic Contact ID and SIA format reporting codes.
Contact ID: The first digit (in parentheses) will automatically be sent by the control. The second
two digits are to indicate specific information about the signal. For example, if zone 1 is a fire zone,
you could program the event code as [1A]. The central station would receive the following:
*FIRE* - FIRE ALARM - 1 where the “1” indicates which zone went into alarm.
SIA Format – Level 2: The SIA format used in this product follows the Level 2 specifications of the
SIA Digital Communication Standard – October 1997. This format will send the account code along
with its data transmission. The transmission would look similar to the following at the receiver:N
Ri00 FA 01
N = New Event
Ri00 = System Event
FA = Fire Alarm
01 = Zone 1
Table 1: Automatic Contact ID/SIA Reporting Codes
Reporting Code Code sent when...
Dialer
Direction*
Contact
ID Auto
Rep.
Codes
SIA Auto
Rep.
Codes
Zone Supv./Rest. zone goes into supervisory/ restore (2) S/R AA See Table 4
Zone Alarms/
Rest.
zone goes into alarm/ alarm condition
has been restored
A/R (1) 3A See Table 4
Zone Trouble/
Rest.
zone exhibits a trouble condition/ zone
trouble condition has been restored
T/R (3) 73 See Table 4
AC Fail Trouble/
Rest.
AC power to control panel is
disconnected or interrupted/AC power
restored; both codes follow the AC
Trouble Delay=
MA/R (3) A1 AT-000/
AR-000
Battery Trouble/
Rest.
control panel battery is low/battery
restored
MA/R (3) A2 YT-000/
YR-000
Ground Fault
Trouble/Rest.
Earth Ground Fault is detected/
restored
MA/R (3) 1A UT-000/
UJ-000
NAC Trouble/
Rest.
NAC circuit is opened/restored MA/R (3) 21 YA-000/
YH-000
Dialer Bus
Trouble/
Rest.
Dialer Bus connection is lost/restored MA/R (3) 33 NT-000/
NR-000
Line 1 or 2 TLM
Trouble/Rest.
connection via Telephone Numbers 1
or 2 is lost/restored
MA/R (3) 51 LT-XXX/
LR-XXX**
Phone # 1 or 2
FTC Trouble/
Rest.
communication is restored after a
failure to communicate trouble has
occurred; events not communicated
during lapse will be sent
MA/R (3) 54 YC-XXX/
YK-XXX**