Quick Start Guide

ST-IP2PTZC QUICK START GUIDE
7
2 Installation
Before you start:
Check the package contents and make sure that the device in the package is in good
condition and all the assembly parts are included.
Note: Do not drag the speed dome with its waterproof cables as shown in Figure 2-1,
otherwise the waterproof performance is affected.
Figure 2-1 Do Not Drag the Cables
2.1 Wall Mounting
Steps:
1. Loosen the two lock screws as shown in the following figure.
2. Remove the lower dome.
Figure 2-2 Disassemble the Speed Dome
3. Remove the protective lens cover, foam and sticker as shown in the following figure.
4. Install the lower dome back and tighten the two lock screws.
Lock Screw
Lock Screw
Back Box
Lower Dome