Quick Start Guide

ST-IP2PTZC QUICK START GUIDE
16
3 Setting the Dome over the LAN
To view and configure the speed dome via LAN(Local Area Network), you need to
connect the network speed dome in the same subnet as your PC. Then, install the
SADP or client software to search and change the IP of network speed dome.
 The following figure shows the cable connection of network speed dome
to PC.
Figure 3-1 Wiring over LAN
 Set the IP address of the speed dome for accessing via LAN.
Steps:
1. To get the IP address, you can choose either of the following methods:
 Use SADP, a software tool which can automatically detect network speed domes
in
the LAN and list the device information like IP address, subnet mask, port number,
device serial number, device version, etc., shown in Figure 3-2.
 Use client software to list the online devices. Please refer to the user manual of
client software for detailed information.
2. Change the IP address and subnet mask to the same subnet as of your PC.
Refer to the following instructions to set IP address with SADP software:
 Search active devices online
Search online devices automatically:
After launching the SADP software, it automatically searches the online devices
every 15 seconds from the subnet where your computer is located. It displays the
total number and information of the searched devices in the Online Devices
interface. Device information including the device type, IP address, port number,
gateway, etc. will be displayed.
Speed Dome
Net
PC
Switch
NVR