Quick Start Guide

ST-IP2PTZC QUICK START GUIDE
14
5. If you route cables from the top of the back box, mark the cable hole on the ceiling
and drill a hole.
6. Secure the mounting base to the ceiling with set screws.
Figure 2-15 Mark the Screw Positions
 If the speed dome is installed to a wooden wall, use the self-tapping screws to secure
the mounting base.
 If the dome is installed to a cement wall, drill three Φ5 mounting holes onto the wall
according to the hole locations, and then insert the cement screws into the holes and
finally use self-tapping screws to secure the mounting base to the wall.
7. Install the speed dome to the mounting base.
Steps:
1). Route the cables for the speed dome. Align the bottom of the speed dome with
the mounting base.
2). Line up the direction of arrow with the spring end of the mounting base.
3). Push the speed dome upwards and then forwards in the direction of arrow. When
the speed dome is placed in position, the spring will automatically snap into the
lock clip firmly. Refer to the following figure.
Screw Holes
Cable
Hole