Quick Start Guide

ST-IP2PTZC QUICK START GUIDE
11
Note: ±2mm of the diameter of the circle is tolerable.
Figure 2-9 Draw and Cut a Hole on the Ceiling
5. Connect the cables.
The cables have been connected to the corresponding interfaces. Connect the power
cable and the red LED indicator turns on when the power is on.
Note: Please turn the power off after checking the speed dome.
6. Install the speed dome to the ceiling.
Steps:
1). Loosen the two lock screws on both sides of the back box and make the locks in
internal position, as shown in the following figure:
Figure 2-10 Locks and Lock Screws
2). Push the speed dome into the mounting hole in the ceiling.
3). Tighten the lock screws with the screwdriver and the locks will automatically
rotate outwards to secure the in-ceiling mount to the ceiling.
Lock
Lock
Φ 224