User Manual

Page.4.
2.3.9 Cable tester
Connect a LAN cable or a telephone cable from the IP BUDDY+ unit to the included blue remote cable tester. The unit will
test for connection status, cable type and the status of each wires conductivity will be displayed.
2.3.10 PTZ data analysis
Test the PTZ control command data to diagnose any errors or to ensure there is a sufficient RS485/RS232 data
transmission. The unit receives the control protocol code (PELCO-D, etc.) from a PTZ keyboard or a DVR with a
RS485/RS232 interface.
The unit will display 16 hexadecimal codes such as:
PELCO-P：A0 00（Add） xx xxxxxx AF xx
PELCO-D：FF 01（Add）xx xxxxxxxx
2.3.11 Digital Image zoom on the monitor
Set image zoom up to 4X to get a closer look at all the image detail. Supports analog and many IP cameras.
2.3.12 Video screenshot, record and playback
Capture the video image displayed and save as a JPEG file. You can also record and save the current video to the SD card..
2.3.13 DHCP dynamic address assignment
Built in DHCP server: Dynamically assign IP address for the IP camera or network device.
2.3.14 Access the dynamic IP address
The IP tester can directly access a dynamic IP address assigned from its DHCP server and use it as the tester’s IP address.
No need to set a IP address manually.
2.3.15 Multiple network IP Cameras Test
Supports Multi- segmented Static IP address setting which can simultaneously test different segments of IP network
cameras.
2.3.16 IP address scan
The IP address scan can quickly search for connected IP cameras or another network device IP address.
2.3.17 PING Test
PING is the most conventional network debugging tool; it is used for testing if the connected IP camera or other network
equipment is working normally and the IP address is correct.
2.3.18 Port flashing
The tester will send signals to make the connected PoE port flicker at a set frequency. This will enable the installer to
easily and quickly find the connected port for an Ethernet cable.
2.3.19 PoE Test
Test the PoE voltage from a PoE switch. The unit will clearly display the voltage for each wire in an Ethernet cable.
2.3.20 LED flashlight
Press the LED On/Off button to use the LED flashlight.