User`s manual

• • Adding Cameras

To add a camera to your system, simply highlight any of the

available cameras/channels (unlocked) and press the OK button

on the receiver. Once selected, a conﬁrmation screen will pop

up asking you to conﬁrm (YES) or cancel (NO) your selection,

use the LF and RT buttons to make your selection and press the

OK button to conﬁrm. During the registration process a pop up

window showing “Add/Remove Camera” will be displayed for

approximately 10 seconds. At this time press the pairing button

located on the back of the camera a few times until you get a

conﬁrmation stating that “pairing was successful”.

NOTE: When adding a camera, the pair button located on the

back of the camera must be consecutively after pressing the

OK button on the DVR/Receiver. There is a 10 second grace

period for adding cameras, if pairing is unsuccessful before the

10 second grace period has expired than a pop up displaying

“operation failed” will appear. Pairing must be done within 20 ft

from the receiver.