Installation Guide

2. At the CMS main screen, click on “System”, and then “Add/Remove
IPCam” to open the device manager window to configure as
illustrated below.
3. In “Add/Remove IPCam” window, click on “ADD AREA” to open the
“Zone” window as illustrated above.
4. In “Zone” window, please enter a zone name, and then click “OK” to
confirm and go back to the Add/Remove IPCam window. In this Quick
Start Guide, we use “Demonstration” as illustrated below.
5. In “Add/Remove IPCam” window, click to highlight “Demonstration”
then click “ADD DEVICE” to open “Edit” device window as shown
below.
6. In “Edit” device window, put a check mark on “IP Address” then click on
the “IP Search” button to start searching for IP address of IP camera.
After clicking on the “IP Search” button, it will detect and list two IP
addresses: 192.168.1.10 (Ethernet) and 192.168.1.11 (Wifi), and they are
the default IP addresses of the IPCam-SD. Put a check mark on the
first IP address (Ethernet), and then click on “EditDevice” button as
illustrated below.
7. In “EditDevice” window, please modify the default IP Address
(Ethernet), Subnet Mask, and Gateway to match your local area
network settings. [To find your local area network settings; on your
computer click “Start”→“All Programs”→”Accessories”→”Command
Prompt”. At the DOS “command Prompt” screen, type “ipconfig”, and
then press “Enter” as illustrated below. Please write down your local
“IPv4 Address”, “Subnet Mask” and “Default Gateway”. Exit from the
“Command Prompt” window.]
8. Go back to the “EditDevice” window to change the “Subnet Mask”
and “Default Gateway” to what you wrote down on Step 7. The final
step is to assign an IP address to the IPCam-SD. There are 4 sets of
numbers in an IP address. The first three sets have to be the same as
“Default Gateway” and then assign the 4th set of numbers between
100~200 (for example 189) as illustrated below. Then click “Modify”
to confirm the changes. If everything is setup correctly, you will get
“Save Config to device successful” window, click “OK” to advance
to the “ADD DEVICE” window. In this Quick Start Guide, we use
192.168.248.189 for demonstration purpose only.
NOTE: please jot down the HTTP Port, Media Port, and Media Port.
9. In “Edit” device window, click the “IP Search” button to re-scan for the
IPCam-SD addresses. Then click on the new IP address (Ethernet) to
make the change and then click the “OK” button to confirm the change
and to go back to the “Add/Remove IPCam” window. Click “OK” again
to go back to main CMS window.
Note: Repeat Steps 2 ~ 9 to setup IPCam-SD wireless connection.
3 4