Installation guide
Table Of Contents
- 1 Introduction
- 2 Architectural Overview
- 3 First-Time NT500 Offline System Installation & Setup
- System requirements
- Navigating the software
- Installing the system
- Defining the system
- Setting up organization options
- Creating time and mode profiles
- Setting up hardware
- Creating cardholders and operators
- Configuring a lock using a laptop
- Configuring an office admin kit as an enrollment station
- Viewing events, diagnostic information, and reports
- Database backup and restoration
- Glossary of Terms
Chapter 3: First-Time NT500 Offline System Installation & Setup
3 – 39
NotesGuard: Alarm Viewer only and no auto-logout.
Manager: Read access to all facilities except Operators; plus
write access to cardholders and add access to event
archiving.
Security Manager: Read access to all facilities except Operators,
Event Archiving and Audit Trail; plus write access to cardhold
-
ers, access groups, areas, time/mode profiles, holiday pro-
files.
Operator: Write access to all facilities except Hardware, Alarm
Map Designer, Card Designer, Event to Action and Audit Trail.
Supervisor: Write access to all facilities.
Installer: Write access to all facilities except Hardware.
To display and allocate operator privileges
1 Click the Privileges tab of the Operator window.
2 If multiple organizational units exist, select the
Organization.
Note: Organizational units are a means of segregating the
NT500 database into logical units which enables sites to be
managed separately. It prevents unnecessary controller
downloads and prevents operators from editing sites which
they should not have any jurisdiction.
Figure 3.21 Allocating operator privileges