Full Product Manual

22
Motion Detection snapshots can be enabled / disabled on a “Per
Camera” bases and is identified by a Walking Person icon located at the
top of each cameras live view screen. Motion detection can be activated
/ deactivated by following the steps below.
1. Tap the Menu icon on the receiver and then tap on the Settings icon.
2. Tap on the Camera icon and select which camera you want to enable /
disable motion detection recording on.
NOTE: You can switch between cameras by tapping on the “<” & “>”
icons.
3. Now select Motion Detection from the available options and select
the desired sensitivity level for the camera being configured.
NOTE: When you are done, you can press the back arrow located to
the right of the Camera label to go back to the previous screen or you
can switch between cameras by tapping on the “<” & “>” icons to begin
configuring the next camera.
Motion Detection Snapshot