User`s manual

Adding and Cancelling Smart Door/Window Sensor:

To Add:

Step 1: Press PRGM + Password + ENT + 70 + ENT+ XX + ENT

The “ ” light will appear solid blue.

[The XX indicate zone number of the 1st defense line, including zones 06 through 10 ].

Step 2: Triggers the Smart Door/Window magnet twice consecutively, the alarm host will beep in series and the

“ ” light ﬂashes ﬁve times and then turns off to indicate the magent Smart door/ window sensor has been

success fully added.

To Cancel:

Press PRGM + Password + ENT + 71 + ENT+ XX + ENT

The alarm host will beep twice then the “ ” light

will ﬂash once and then turn off to indicate the magnet Smart door/ window sensor has been successfully cancelled.

[The XX indicate zone number of the 1st defense line including zones 06 through 10].

Note: The alarm host can only learn 1 wireless device (Magnet Smart Door/Window Sensor) at a time, a total of 4

wireless devices (magnetic sensors) to a zone can be added. For example; for the 1st defense line, if 4 sensors were

to be added to zone 06 through zone 10, there would be a total of 20 sensors in all. If 1 device is removed from a

zone that contain 4 devices, then all 4 devices in the zone will be removed, and each device will have to be added

again by following the “To Add” proceedures above.

Wireless Doorbell Button (SM-82)

Doorbell Button Back Mounting Bracket

* please use screws (F) to install the mounting bracket. (see page 26)

Functions/Features:

• Installed on an entrance door.

• The alarm host will make 3 “Ding Dong” sound per ring.