User manual

6
Set HOME Position
a. Setting the HOME position is very similar to setting Preset Positions.
b. Using the LEFT/RIGHT and UP/DOWN buttons move the camera to the desired
Home Position.
c. Press PRESET and hold for 3 seconds.
d. Press HOME followed by ENTER to confirm.
Set A and B Limiting Positions
a. Setting the A and B Limiting Positions is very similar setting Preset Positions and the
HOME position.
b. Using the LEFT/RIGHT and UP/DOWN buttons move the camera to the desired A
Position.
c. Press PRESET and hold for 3 seconds.
d. Press A followed by ENTER to confirm.
e. Repeat the above steps for the B Limiting Position.
Delete HOME and A and B Limiting Positions
a. Press and hold DELETE for 3 seconds. The PT Controller’s screen will display
b. Press HOME, A or B followed by ENTER to confirm.
Set Up and Run Pattern Tour
A Pattern Tour allows the camera to automatically track a select group of Preset Positions.
a. Pressing PATTERN once puts the ST-PTZ-RC into Pattern
Track Setup Mode. The PT Dome Controller will display
b. In the setup mode up to 16 pre-existing Preset Positions
can be selected. For example, if the camera is to tour Preset Position 6, Preset
Position 2, Preset Position 3 and Preset Position 8:
 Press SHOT, 6, ENTER
 Press SHOT, 2, ENTER
 Press SHOT, 3, ENTER
 Press SHOT, 8, ENTER
d. It is possible to set both the camera movement speed from one Preset Position to
another as well as the dwell time the camera stays on a Preset Position. See “Set
Speed” below for details.
e. To end the Pattern Track Setup Mode press PATTERN and
the PT Dome Controller will display
CLr-
PStA
PStO