User manual

v2.0 11/8/11
47
 NEED SSL – Highlight the checkbox if the Secure Socket Layer protocol is required.
 USER NAME – Enter the email server user name.
 PASSWORD – Enter the email user’s password.
 SENDER – Set the email sender address.
 RECEIVER – Send the email to appointed receivers when the alarm takes place.
There is a maximum of three receivers.
 TITLE - Create a title for the email subject line.
e. IP FILTER – It is possible to create an IP address “white list” that identifies those IP
addresses allowed to connect to the DVR. When creating an IP address “black list”, the
listed IP addresses cannot connect to the DVR. 64-bit IP addresses are supported on both
“white” and “black” lists. If an IP address is on both the “white” and “black” list the “black”
list takes precedence. The IP Filter configuration screen is similar to the one below.
Highlight the ENABLE check box.
f. DDNS – Dynamic Domain Name Server. DDNS permits a DDS name to be synchronized
with a dynamic IP address. The DDNS configuration screen is similar to the one below.
Highlight the ENABLE checkbox. Note: DNS must also be configured correctly under
Network setup. When the DDNS is successfully configured and started the domain name
can be connected in an Internet Explorer address toolbar.