Installation manual

7
5. SETTING CAMERA ADDRESS, PROTOCOL and BAUD RATE
The camera’s address, protocol and baud rate are set using the camera’s
On Screen Display menu.
When the camera powers up, it will display the default protocol, address
and baud rate, which is:
 Protocol: Pelco D
 Address: 1
 Baud rate: 9600
To access the menu, set your PTZ controller to match these default
settings then press “Iris Open” or “Open” on your PTZ controller.
The MAIN MENU will display:
Use the UP and DOWN buttons of your controller to highlight
PROTOCOL SETUP then press OPEN to access the PROTOCOL
SETUP menu.