Installation manual

9.4 AUTO RETURN HOME

Use the UP & DOWN buttons to select AUTO RETURN HOME

and use the LEFT & RIGHT buttons to set it to either START or

STOP. When set to START, the camera will be enabled to return

to a user-selected home point after a lack of user input determined

by HOME DWELL TIME described in # 9.5, below.

When set to STOP, the camera will not return to its home point.

9.5 HOME DWELL TIME

This is the amount of time, in seconds, that the camera will wait

after receiving its last PTZ command before returning to the user-

selected HOME point. The home point is set using # 9.6 HOME

POINT SETUP, below.

Use the UP & DOWN buttons to select HOME DWELL

TIME and use the LEFT & RIGHT buttons to set it to the desired

dwell time.

9.6 HOME POINT SETUP

To set the HOME POINT position for the camera, exit the menu

and use the PTZ controller to direct the camera to view the point

which you would like to be the HOME POINT.

Re-enter the menu, and navigate back to this parameter, then

press OPEN to lock in the current camera view as the HOME

POINT.