Installation manual

27
8.2 TILT LIMIT SET
Tilt limit will set a specific point, beyond which the camera will not
tilt.
To enable a tilt limit, first exit the menu and use the PTZ controller
to set the camera to the vertical height (tilt) to be used as the limit.
Enter the camera menu and use the DOWN button to highlight
PAN TILT SETUP, then TILT LIMIT SET. Press the OPEN button
to set the current tilt position as the tilt limit. To remove the tilt limit,
use the next function described in # 8.2 TILT LIMIT RESET, below.
8.3 TILT LIMIT RESET
This function removes any tilt limit was set in the previous step
above. Use the UP & DOWN buttons to select TILT LIMIT RESET
and press the OPEN button to remove the tilt limit.
8.4 PAN TILT LIMIT SPEED
The number set for this parameter will determine the maximum
speed at which the camera can move (pan or tilt). This can be
useful if the PTZ controller being used does not have the ability to
control the camera at lower speeds. The value ranges from 1 ~ 63,
with 63 being 100% full speed operation.
8.5 ZOOM LIMIT SPEED
The number set for this parameter will determine the maximum
speed at which the camera’s lens can zoom. The value ranges
from 1 ~ 63, with 63 being 100% full speed operation. 63 is the
recommended setting.