User manual

v2.0 11/8/11
42
Network Service Settings
From the Main Menu click the System icon followed by the NetService icon. A NetService
settings screen similar to the one below will be displayed.
a. Choose the network service option by highlighting it with the mouse or front panel
UP/DOWN buttons. Then click the SET button to display a configuration screen for that
particular service. Once settings are entered into the configuration screen click OK then
OK on the NetService setting screen.
b. PPPOE - Point-to Point Protocol Over Ethernet. PPPoE is a specification for connecting
the users by Ethernet to the Internet through a common broadband medium. PPPoE
generally involves the use of a DSL modem or cable modem. If PPPoE is to be used the
IP address, account name and password are required. The system must be rebooted
after saving. After the reboot the DVR will automatically setup the PPPoE network
connection and the ISP will modify automatically the Internet dynamic IP address. This
new IP address is to be used for remote access to the DVR. The PPPOE configuration
screen is similar to the one below. Highlight the ENABLE checkbox.
c. NTP – The NTP server must be installed on the PC. The NTP configuration screen is
similar to the one below. Highlight the ENABLE checkbox.