User manual

v2.0 11/8/11
30
b. Connect the PTZ camera’s video cable to the DVR’s video input port.
c. Power the PTZ camera after all connections are made.
PTZ Camera Configuration
Setting up the PTZ camera for DVR control is done by the following steps:
a. From Main Menu, click the System icon then the PTZ Config icon. A PTZ Config screen
similar to the one below will appear.
b. In the CHANNEL drop-down box select the DVR channel the PTZ camera is on.
c. In the PROTOCOL drop-down box select the PTZ camera’s protocol (e.g, PELCOD).
d. In the ADDRESS field input the PTZ camera’s device ID (e.g., 1).
e. In the BAUD RATE drop-down box select the PTZ camera’s baud rate.
f. In the DATA BIT, STOP BIT, and PARITY drop-down boxes select the parameters that
match those for the PTZ camera. Defaults are respectively 9600, 8, 1, and NONE.
g. MONITORS is not used in this DVR.
h. Repeat the above steps for each PTZ camera to be connected and controlled.
i. Once all settings are made click the OK button and exit.