User manual

Assembly of the bike repair stand
1. First you open up the stand base. To do this open the lower
quick-release (1) on the stand pipe and press it down, so that
the stand base is fully deployed. Then close the quick release
again.
2. Stand the repair stand into upright position. Loosen the upper
quick-release (2) and pull the telescopic tube (3) to the desired
length. Adjustable height of about 100 - 170 cm.
For fixation close the quick release again.
3. Open the quick-release (4) at the end of the telescopic tube
and push the holding arm (5) into the receiving aperture. The
holding arm may be only pulled so far that its end is flush with
the receiving aperture. For fixation close the quick release
again.
4. Put the bracket of the tool tray around the standpipe and put
the screw in the notch. Turn the screw tight.
Folding together is in the reverse order
Attachment of a bicycle on bike repair stand
Please check the bike stand on damages and the tightness
of all screws before inserting the bicycle.
1. Loosen the screw (6) of the retaining clamp so far that the
frame or seatpost can be hooked in smoothly.
2. Set the arm in the for mounting desired position .
For this, open the quick-release (4),do the setting and then
close the quick release again.
3. Hang the bike with the frame or seatpost in the retaining
clamp and tighten the screw (6).
Disassembly is in the reverse order.
-3-