Troubleshooting guide
A–1
APPENDIX A
5800 RF System Wireless Transmitters
••••••••••••••••••••••••••••••••••••••••••••••••••
5800 Series Transmitter Input Loop Identification
All of the transmitters illustrated on the next page have one or more unique factory-assigned input
(loop) ID codes. Each of the input loops requires its own programming zone (e.g., a 5804's four inputs
require four programming zones).
Transmitter inputs entered as:
“RF”
(Supervised RF) Type
send periodic check-in signals, as well as fault, restore, and low-
battery signals. The transmitter must remain within the receiver's range.
“UR”
(Unsupervised RF)
Type send
all
the signals that the “RF” type does, but the control does
not supervise the check-in signals. The transmitter may, therefore, be carried off-premises.
“BR” (Unsupervised Button RF) Type
only send
fault
signals. They do not send low-battery,
restore, or check-in signals. The transmitter may be carried off-premises.
LOOP
1
5802MN
ENROLL AS "UR" OR "RF"
YOU MUST
ENROLL THIS
BUTTON
LOOP 3
LOOP 1
LOOP 2
LOOP 4
LOOP
1
5808
ENROLL AS "RF"
5804
ENROLL
AS "BR"
5817
ENROLL AS "RF"
LOOP
1
(PRIMARY)
2
(AUX. CENTER)
3
(AUX. RIGHT)
LOOP
1
(MOTION)
5890
ENROLL AS "RF"
5816
ENROLL AS "RF"
LOOP
2
(REED)
LOOP 1
(TERMINALS)
5827
SET HOUSE CODE
5827BD
SET HOUSE CODE
5816MN
ENROLL AS "RF"
LOOP
2
(REED)
LOOP 1
(TERMINALS)
5819
ENROLL AS "RF"
LOOP
2
(REED)
LOOP 1
(TERMINALS)
ALTERNATE
POSITION
FOR LOOP2
LOOP 3
(TERMINALS)
5819S (WHS & BRS)
ENROLL AS "RF"
LOOP
2
(REED)
LOOP 1
(INTERNAL
SHOCK
SENSOR)
LOOP 3
(TERMINALS)
5850 (GBD)
ENROLL AS "RF"
(Green)
(Red)
(Yellow)
5804BD
ENROLL AS "BR"
LOOP 3
LOOP 1
LOOP 2
LOOP 4
SET
HOUSE
CODE
YOU MUST
ENROLL THIS
BUTTON
LOOP
1
5809
ENROLL AS "RF"
5801
ENROLL AS "UR" OR "RF"
LOOP 3
LOOP 1
LOOP 2
LOOP 4
YOU MUST
ENROLL THIS
BUTTON
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Note
: For information on any transmitter not shown above, refer to the instructions
accompanying that transmitter for details regarding loop numbers, etc.
U
L
The 5802MN, 5802MN2, 5804, 5804BD, 5814, 5816TEMP, 5819, 5819WHS & BRS, 5827BD,
and 5850 transmitters are not intended for use in UL installations.