Use and Care Manual

TEMPAL
TM
Technical Specifications
Min environmental temperature for included probe 0
0
F (-18
0
C)
Max environmental temperature for included probe 180
0
F (82
0
C)
Max case environmental temperature 160
0
F (71
0
C)
Power supply 12VDC (210mA consumption)
Video input source Requires standard composite 75 ohm, 1v p-p video
Menu Three button nested programming, 7 screens
Alarm output Selectable Normally Open (NO) or Normally Closed (NC)
Alarm contacts TTL (0-5V/ 50mA max)
Temperature alarm Any value outside the user programmed range
Calibration Adjustable temperature value for matching to another device
Screen display Temperature can be positioned anywhere on screen
Screensaver mode Mode enables display to move around screen randomly
Temperature probe 6’ 22 gauge sensor wire included
Case size 2.6” W x 4.3” D x 1.1” H
Limited Product Warranty
TEMPAL
TM
: ONE YEAR PARTS AND LABOR
Should this product prove to be defective in material or workmanship under normal usage, we will provide
without charge to the consumer, parts and/or labor necessary to remedy the defect for the period of ONE YEAR
from the date of purchase. The warranty period commences on the date that the product is purchased by the
consumer. Any implied warranty is also limited to the duration above.
THIS WARRANTY DOES NOT COVER THE FOLLOWING: FLUCTUATIONS IN THE POWER SOURCE OR
LIGHTNING-RELATED DAMAGE; ATTACHED OR UNATTACHED ACCESSORIES; COSMETIC PARTS SUCH AS
KNOBS AND ACCESS DOORS; CABINET DAMAGE, INCLUDING DAMAGE IN TRANSIT; ACCIDENTAL DAMAGE;
MISUSE; ABUSE; UNAUTHORIZED PARTS USAGE OR REPAIRS; RECEPTION PROBLEMS DUE TO INADEQUATE
SIGNAL; UNAUTHORIZED INTERNAL CONTROL OF ADJUSTMENTS; INSTALLATION; ADJUSTMENT OF
CONSUMER CONTROLS; EXCEEDING THE MAXIMUM OR MINIMUM RATED LIMITATIONS OF THE PRODUCT AS
OUTLINED; OR ANY USE OF THE PRODUCT OTHER THAN THAT SPECIFICALLY PRESCRIBED IN THE OWNER'S
MANUAL. THIS WARRANTY APPLIES TO PRODUCT SOLD AS NEW AND NOT REMANUFACTURED,
RECERTIFIED, OR B STOCK PRODUCTS.
THE MANUFACTURER’S OBLIGATION UNDER THIS WARRANTY SHALL BE TO REPLACE SUCH PARTS AND
PROVIDE LABOR AS STATED. THE MANUFACTURER WILL NOT BE LIABLE FOR ANY LOSSES OR
INCONVENIENCES DIRECT OR INDIRECT, OR CONSEQUENTIAL PROPERTY DAMAGES.
To obtain warranty service, the consumer must provide the product, along with evidence that will positively identify the
date that the product was purchased, from an authorized product representative, dealer, retailer, or distributor. Prior to
shipment, a RETURN AUTHORIZATION must be obtained; this will assist us in efficient service on your unit, and possibly
avoid shipment if the adjustment can be made over the phone. If shipment is made, the cost for postage, insurance and
shipping of the product is the responsibility of the owner.
To obtain a warranty return authorization number, contact our Customer Service at:
Security Labs Customer Support 1-800-774-0284 www.security-labs.com