Use and Care Manual

Need Authentication - Check the box if the email needs authentication then
input the SMTP User Name & Password.
Mail test: Set the Mail parameters then click 'Submit' first before sending a
test email. “Success” will be the response on your screen if the e-mail
parameters have been entered correctly.
Report Internet IP by Mail – Sends an e-mail when the camera is powered
up or the IP address is changed.
FTP Service Settings
Note: When Alarm Service Settings > Upload Image on Alarm is checked, the
FTP Service takes effect.
FTP Server - The FTP server address.
FTP port - The port usually is 21.
FTP Mode - Supports standard (POST) mode and passive (PASV) mode.
Upload Image Now - Check the box to upload the image. When checked, you
can input the upload interval time in seconds.
FTP Test - Set the FTP parameters and then click 'Submit' before testing the
FTP settings. If successful, it will display the prompt “Success”.
Alarm Service Settings (Motion Detection)
Enter the Alarm Service Settings page to configure the Motion Detection