Use and Care Manual

49
3.10 Utility
Item Description
HDD Initialization (Format).
THIS STEP WILL ERASE
ALL VIDEO DATA
FROM YOUR HARD
DRIVE.
Select to enter the hard disk initialization menu. This step should be
performed whenever installing a new hard drive, or if you change the time /
date settings on your DVR. Please stop recording before entering
this menu. System will show all the data (model/ volume) of HDD that is
installed in the DVR. Check the HDD you’d like to initialize, and then press
“Start”. HDD initialization is successful when the status shows “Succeed”.
USB Initialization
Clears all data on your USB drive. . Enter USB initialization and press “YES”.
The initialization is done when “Succeed” is displayed.
System Recovery
Restores all settings to factory default values.
Reset System Events
Clears the event logs.
Copy Setup to USB
You can transfer your setup configuration to another (same model) DVR
using this command via a USB flash drive. There will be a file named
“sdvr.config” on your USB drive when finished.
Download Setup from USB
Download the configuration file from a USB device into the same model
DVR.
Upgrade
The operational firmware for your DVR can be upgraded if needed.
Please contact Customer Service @ 800-774-0284 for details first. An
improper file installed can also render your unit inoperable! Please stop
recording and backup setup configuration before upgrading.
System will reboot automatically when the upgrade is completed.