Specifications

Page11of30

• Each of these streams must be independently configurable to view and record at different frame
rate and resolutions simultaneously.
• Each Video stream should in turn allow for TCP connections, UDP connections and an unlimited
number of Multicast connections.
• Each stream must allow independent configuration of bit rate, frame rate, I frame interval, rate
control mode and motion data.
• All streams must guarantee full frame (25fps) rate under high motion, PTZ operation and all
conditions. A certification from the manufacturer is required to prove this and will need to
be shown during demonstration.
• The IP Camera must support Capped Bit Rate (CBR) control, to enable users to keep bandwidth
utilization under a certain value without compromise on image quality irrespective of the level of
motion in the scene.
• The IP Camera must support Activity Controlled Frame Rate control to automatically adjust
frame rate depending on motion in the scene. During periods of negligible motion, the frame rate
must drop to 1fps and when motion occurs the frame rate will return to full frame rate
(30fps/25fps) within 100ms. It must be configurable using a Region of Interest editor (ROI) that
can select regions of the scene where motion will be ignored.
• Support network protocol 802.3 and IETF Standards10/100 Base-T Ethernet, RTP/RTCP,TCP,
UDP, ICMP, SNMP, HTTP, FTP, TELNET, MULTICAST, ARP and IGMP
• Each stream Bit-rate should be user configurable from 32 to 4096 Kbps or better
• The IP Camera will have a built in web server, making it accessible for configuration using a
standard Internet browser.
• The IP Camera must be compatible to support advanced analytics software which should be able
to perform the following:
- Intelligent Motion Detection
- Virtual trip wire
- Left item detection
- Theft detection
- Object tracking
- Counter flow detection
• Must have minimum 1 alarm inputs and 1 relay outputs
• The IP Camera must support redundant recording by streaming to multiple recorders at the same
time.
• Should be able to detect motion based on localized area, object size & direction
• It must be possible to reset a unit back to Factory Default configuration without losing IP address
information.
• Video Output PAL/NTSC
- Composite Video
• Serial Data Port supporting RS232/ RS422/ RS485
• Password protected Web interface for administration
• Should have onboard diagnostics facility for serial, Video & Network interface. System logging
shall be possible to a remote IP address, the console port or the unit itself.
• Must support a standard operating temperature range 0 to +50
۫ C with extended temperature
range units available from -10
۫ C to +60 ۫ C
• The system MUST be able to use one particular framerate and resolution at Day time and
automatically switch to another frame rate/resolution profile when low light conditions occur
• The system MUST allow for Telnet/FTP  access into the units and also this access MUST be
configurable,whereinwhenactiveaccessisallowedandwhendeactivatedaccessMUSTnotbe
allowed.


(c ) IP PTZ Camera (Outdoor Type)