Specifications
Page10of30
TECHNICAL SPECIFICATIONS:
(I) IP CCTV SURVEILLANCE SYSTEM :
(a) IP Video System Overview:
• Transmit and Receive H.264 and MPEG-4 Video and bi-directional Audio.
• Video and alarm management software under one single front end and should be on open
platform with support to to renowned IP camera brands ( like Axis, Pelco, DvTel, Honeywell,
Panasonic, Sony etc.)
• Support for multi user and multi user group environment in addition to user hierarchy
• System should allow to be used as a distributed or central architecture with support to any
number of cameras and any number of clients that may be added in future.
• System Guarantees Bandwidth & Frame rate control.
• Provides Activity Controlled Frame rate, which in turn reduces the Bandwidth and the Storage
requirements.
• Provides Broadcast quality Video across IP network including Internet.
• Provides multiple failover and network resilience.
• Provides real time recording at 25fps with no frame loss.
• Provides PTZ Camera Controls & Binary INPUT/OUTPUT controls.
• Supports Multiple IP Video Streams.
• Secured recording for evidence purposes and user authentication to protect data integrity.
• Video Stream bit rate selectable from 32 to 4096kbps.or better
• All the IP cameras shall have SD card slot for recording in SD card when network is down/fail
(b) IP Fixed Box Camera (Outdoor Type)
• Latest Sony Ex View 1/3” or 1/4" interlaced imager/ progressive imager CMOS or better
• Verifocal lense 5-50 mm
• Camera must provide atleast 704x576 (PAL) active pixels @ 25 fps
• Color Resolution 540 TV Lines/ 704x576 pixels or better for sharp pick up of live video.
• Minimum Sensitivity of Day: 0.5 Lux; Day/Night: 0.5 lux in color / 0.05 lux mono
• Gain Control Automatic
• White Balance Mode: Auto; Fluorescent; Indoor; Outdoor
• Shutter Speeds 1/60 to 1/100,00 (NTSC), 1/50 to 1/100,00 (PAL) or Auto*
• Operating voltage: Power over Ethernet (802.3AF); 12V/24V AC/DC
• The IP Camera should support a Receiver Driver Unit or a motorized zoom lens
• The hardware architecture must incorporate multiple processors to ensure best video quality and
other functions even at maximum processor load.
• The IP Camera system must offer a choice of either MPEG-4 Advanced Simple Profile or H.264
video compression standards, by just upgrading the firmware over the network without
dismantling the camera.
• The IP Camera must run Linux Operating system for reliability.
• The camera must have a built in firewall - SSL and other non-IP address specific security
measures are deemed insufficient
• Should support and allow configuration of the following video resolutions or better.
- 352 X 288 (SIF)
- 704 X 576 (4 SIF)
- 704 X 288 (2 SIF)
• When running on MPEG-4 / H.264 compression, the video codec should support atleast 2
simultaneous streams at resolutions between 4SIF and SIF.