User`s manual

15
Video Setup Screen
The video setup screen allows you to mask an area of any channel from being viewed, and set
the notifications that will happen should the video from a camera be lost. Select a channel and
click on <Setup> to mask an area from being seen or recorded. Left click and drag the mouse
to create a green rectangle over the area, then click <Save & Exit> in the top right corner. To
remove the mask, click <Video Setup> from the Main Menu, select the channel involved, click
<Setup>, then click the gray edge to the left of the green mask to delete it, then click <Save &
Exit>.
Check “Buzzer Alarm” or “Send E-mail” if that notification is desired for any selected channel.
The default for “Video Mode” is NTSC and should remain so for all regions of North America.
Click the <Motion Detection> tab to the right to bring up the screen below.