Installation guide

Digital Monitoring Products XT30/XT50 Programming Guide
12
meSSaging SeTuP
5.8
EMAIL O/C NO YES
Email O/C
Select YES to allow the panel to send Opening and Closing reports via email. Default is
NO. This prompt appears only if any destination above is an email address.
5.9
SMS O/C NO YES
SMS O/C
Select YES to allow the panel to send Opening and Closing messages to a cell phone via
SMS protocol. Default is NO. This prompt appears only if any destination above is a
cell phone number.
The remaining options will only appear if email messaging has been selected to be sent via network. The options
allow the email server to be selected by the installing dealer. Typically this will be the email service provided by the
installing dealer. This allows opportunity for additional services to be provided to the end user.
5.10
SMTP SERVER
-
SMTP Server
Enter the SMTP (Simple Mail Transfer Protocol) Server name. The SMTP email server
is responsible for sending the email to its destination. An example SMTP email
server name is: mail.somedomain.com. The domain should be the email server
that will provide email support for your alarm customers.
5.11
SMTP PORT: 25
SMTP Server Port
The SMTP server port number is the port that the panel uses to initiate a TCP
connection with the email server. The default port is 25.
5.12
SMTP USERNAME
SMTP Username
-
Most SMTP servers require a username to send email. This will be sent to the SMTP
server in conjunction with the SMTP Password to provide email authentication to the
server.
5.13
SMTP PASSWORD
SMTP Password
-
Most SMTP servers require a password to send email. This will be sent to the SMTP
server in conjunction with the SMTP Username to provide email authentication to the
server.
5.14
FROM EMAIL
From Email Address
-
Enter the email address on le with the email service. This will show up in the email
messages as the sender’s address.