Installation guide
XT30/XT50 Programming Guide Digital Monitoring Products
9
CommuniCaTion
3.16
O/C USER NO YES
Opening/Closing and User Reports
YES enables Opening/Closing, Door Access, Schedule and Code Changes, Bypass, and
Sensor Reset reports by user to be sent to the receiver. Default is YES.
3.17
-
-
FIRST PHONE NO.
First Telephone Number
Enter the rst number the panel dials to send reports to a receiver. A phone number
may contain two lines of 16 characters to equal 32 characters. You can program
a three-second pause in the dial ing se quence by en tering P. Program a dial tone
detect by entering D. These characters are counted as part of the 32 characters.
Call Waiting: You can place the “* 7 0 P” (Star, Seven, Zero, Pause) in the telephone
number rst position to cancel Call Waiting. For example, program NET with second
line DD and phone number *70P555-1212, and you have NET with Call Waiting
cancelled on the second line.
Caution: A call waiting cancel programmed on a non-call waiting telephone
line would prevent communication to the central station.
3.18
-
-
SECOND PHONE NO.
Second Telephone Number
The panel dials the second number after two successive attempts failed using the
rst number. If the panel cannot reach the receiver after two attempts using the
second number, it returns to the rst number and makes two additional attempts. A
total of ten dialing attempts are made using the rst and second phone num bers. If
a second phone number is not entered, the rst phone number is used for all dialing
attempts. Each number can be up two lines of 16 characters to equal 32 characters
in length, in cluding any P, D, or *70P char acters entered for pause, dial tone detect,
or call waiting cancel option.
3.19
FIRST IP ADDR
000.000.000.000
First IP Address
Enter the rst (primary) IP address where the panel sends network or cell messages.
The IP address must be unique and cannot be duplicated on the network. Enter all
12 digits and leave out the periods. For example, enter IP address 192.168.0.250 as
192168000250. The periods display automatically.
For NET: The rst and second IP addresses are alternately used for 8-second
intervals until successful communication or 1 minute elapses. If communication
fails on the rst IP address and succeeds on the second IP, future network
communication attempts begin using the second IP address.
For Cell: The message is sent using First GPRS APN and the First IP Address. If
no acknowledgment is received, First GPRS APN and the Second IP address are
used, followed, if needed, by Second GPRS APN and rst and second IP addresses,
respectively. Future cellular communication attempts start with the APN/IP
combination of the last successful communication.
3.20
FIRST IP PORT
First IP Port
2001
Enter the rst IP port number to be used in conjunction with the First IP Address.
The IP port identies the port used to communicate messages to and from the
panel. The default IP Port setting is 2001.
3.21
SECOND IP ADDR
000.000.000.000
Second IP Address
Enter the second IP address where the panel sends network messages. The IP
Address must be unique and cannot be duplicated on the network. Enter all 12
digits and leave out the periods. For example, enter IP address 192.168.0.250 as
192168000250. The periods display automatically.
3.22
SECOND IP PORT
Second IP Port
2001
Enter the second IP port number to be used in conjunction with the Second IP
Address. The IP port identies the port used to communicate messages to and from
the panel. The default IP Port setting is 2001.