Installation guide

Digital Monitoring Products XT30/XT50 Programming Guide
4
inTroduCTion
When there are more than four re sponse options avail able, press the COMMAND key to display the next
one to four options. Pressing the Back Arrow key allows you to review the previous four choices.
The Select keys/areas are also used for choosing a section from the pro gramming menu. Press any Select
key or touch the Select Area when the programming section name you want displays.
Note: On Security Command, Thinline and Aqualite keypads, when instructed to press the rst Select
key, press the far left Select key; the second Select key is the second from the left; third Select key is
second from the right; and the fourth Select key is the far right key. See Figures 4 and 5.
On Clear Touch Keypads, when instructed to press the rst Select key, touch Select Area 1; the second
Select key touch Select Area 2; third Select key touch Select Area 3; and the fourth Select key touch
Select Area 4. See Figure 6.
1.8 Entering Alpha Characters
Some options during programming require you to enter alpha characters. To enter an alpha character,
press or touch the key that has that letter written below it. The keypad displays the number digit of
the key. Next, press the Select key/area that corresponds to the loca tion of the letter under the key.
Pressing a different Select key/area changes the letter. When an other digit key is pressed, the last letter
displayed is retained and the process starts over.
First Letter Second LetterThird Letter Special Character
(CBA
First Letter
Second Letter
Third Letter
Special Character
(CBA
Figure 5: Security Command Select Keys Figure 6: Thinline/Aqualite Select Keys
32-Character Display
Select Area 1
Select Area 2
Select Area 3
Select Area 4
Figure 7: Clear Touch Select Areas
1.9 Entering Non-Alpha Characters
To enter a space in an alpha entry, press the 9 digit key followed by the third Select key/area. The three
characters on the 9 digit key are Y, Z, and space. You can also enter the following characters: – (dash),
. (period), * (asterisk), and # (pound sign) using the 0 (zero) key and the four Select keys/areas from left
to right. For example, to enter a – (dash), press the 0 (zero) key and then the left Select key/area. A
dash now appears in the keypad display. The table below shows the character locations for DMP keypads.
Key Number Select Key 1 Select Key 2 Select Key 3 Select Key 4
1 A B C (
2 D E F )
3 G H I !
4 J K L ?
5 M N O /
6 P
Q
R &
7 S T U @
8 V W X ,
9 Y Z space _
0 - . * #