User`s guide

34 XRSuper6 User’s Guide Appendix
Appendix C
Easy Entry™ User’s Guide
This section of the user’s guide provides information on using the Security Command
™
system Easy Entry™ access control capability. If
your system is not currently using any access control devices, disregard this section. The keypad displays for All/Perimeter or Home/Away
operation are dependent on how your keypad was programmed by your alarm dealer. Easy Entry™ is built into every Security Command
™
system and can be accessed using Easy Entry™ keypads.
There are three different operating modes: Door Strike, Arming and Disarming, and Entry Delay. All of the examples below assume that
your system requires a user code to arm and disarm the protection.
DOOR STRIKE
Area and All/Perimeter Door Strike — From the Status List, present your card to the
reader. When the card is validated by the system, the Door Strike relay activates for
5 seconds during which time you can open the door. Once you open the door, you
have 40 seconds to exit and close the door before the Zone 2 Soft-Shunt expires.
Home/Away systems only activate the Door Strike relay when arming and
disarming.
ARMING AND DISARMING AN ALL/PERIMETER SYSTEM
Press COMMAND. The keypad displays PERIM ALL (when arming) or DISARM?. Press
the Select key under the desired option. The keypad displays ENTER CODE: -.
Present your card to the reader. Once the system validates the card, if you choose
PERIM, only the perimeter arms. If you choose ALL, both areas arm. If programmed
on a 32-character keypad, ALL is automatically chosen for you after a short delay. All
armed areas disarm automatically.
ABC SECURITY
MON 10:20 AM
ABC SECURITY
ARM DISARM