Installation guide

XRSuper6/XR20/XR40 Installation Guide Digital Monitoring Products
1
INTRODUCTION
Panel SpeciÞ cations
1.1 Power Supply
Transformer Input: 16.5 VAC 40 VA (Models 320 Wire-in or 321 Plug-in)
Standby Battery: 12 VDC 7.0 Ah (40 VA transformer charges up to 2 batteries)
Auxiliary Output: 12 VDC at 500mA
Bell Output: 12 VDC at 1.5 Amps
Smoke Detector Output: 12 VDC at 100mA
All circuits inherent power limited
1.2 Communication
Built-in SDLC Digital Dialer communication to DMP Model SCS-1 and SCS-1R Receivers
Built-in 4-2 communication to non-DMP receivers
Built-in M2E (Radionics Modem IIe) communication to non-DMP receivers
Built-in CID (Contact ID) communication to non-DMP receivers
Any panel can operate as a local system.
1.3 Panel Zones
Nine 1k Ohm EOL burglary zones: zones 1 to 9 on XR20 and XR40 panels, and zones 1 to 5 on the XRSuper6.
One 3.3k Ohm EOL Class B powered Þ re zone with reset capability: zone 6 on the XRSuper6, and zone 10 on
XR20 and XR40 panels.
1.4 Keypads
You can connect up to four supervised keypads to the XRSuper6/XR20 panels and eight supervised keypads on
the XR40.
• 16 or 32-character alphanumeric keypads
• 10-zone LED keypads
In addition, the following zone expanders can be added to the XRSuper6/XR20/XR40 panels:
• One, four, eight and 16-zone expansion modules
• Single-zone PIR and glassbreak detectors
• One 738A Ademco Wireless interface for up to 32 points of zone expansion
• One FA426 Wireless receiver for up to 16 points of zone expansion (Two FA426 on the XR40)
When using the FA426 Wireless Receiver, you can add unsupervised devices to address Þ ve of the XRSuper6
and XR20.
1.5 Outputs
The XRSuper6/XR20/XR40 panels provide four open collector outputs rated for 50mA each. A Model 300
Output Harness is required. The open collector outputs provide the ground connection for a positive voltage
source.
1.6 Enclosure SpeciÞ cations
The XRSuper6/XR20/XR40 panel ships in an enclosure with EOL resistors, battery leads, user’s guide, and
programming sheet.
XRSuper6, XR20, XR40 in Model 340 Enclosure XRSuper6M, XR20M, XR40M in Model 350 Enclosure
Enclosure size: 12.5” W x 9.5” H x 2.75” D Enclosure size: 17.5” W x 13.5” H x 3.5” D
Color: Gray (G) Color: Gray (G) or Red (R)
Construction: 20-gauge, cold-rolled steel Construction: 18-gauge, cold-rolled steel
XRSuper6M, XR20M, XR40M in Model 349 Enclosure XR40A in Grade A Model 350A Enclosure
Enclosure size: 12.5” W x 11.25” H x 3.5” D Enclosure size: 17.1” W x 13.2” H x 3.7” D
Color: Gray (G) or Red (R) Color: Gray (G)
Construction: 20-gauge, cold-rolled steel Construction: 18-gauge with 16-gauge door