Installation guide

LT-0624 (3/04) © 2004 Digital Monitoring Products, Inc.
800-641-4282
www.dmp.com
Made in the USA
INTRUSION • FIRE • ACCESS • NETWORKS
2500 North Partnership Boulevard
Springfield, Missouri 65803-8877
OPERATING INSTRUCTIONS MODEL
XRSuper6/XR20/XR40 PANELS
When using Model 692 LED Keypad, please refer to 692 User Guide (LT-0275)
NORMAL STANDBY CONDITION
When the system is in the normal standby condition, the keypad shows either the time of day/System
Ready or a blank display.
ALARM CONDITION
When the system is in an alarm condition, the keypad keys glow red and the display shows the violated
zone name(s) followed by an alarm display.
ARMING THE SYSTEM
Press the COMMAND key until arming options appear. Press Select key under the arming option desired,
then enter your user code.
DISARMING THE SYSTEM
All/Perimeter and Home/Sleep/Away Systems: Enter your user code. If the system is in alarm the keypad
will display DISARM SILENCE. Press the Select key under DISARM.
Area Systems: Enter your user code. If the system is in alarm the keypad will display DISARM SILENCE.
Press the Select key under DISARM.
Important: Disarming during an alarm sends an Abort report to the central station if your system is
programmed to send Abort reports! Be sure you want the alarm message cancelled before disarming
during an alarm.
ALARM SILENCE
To silence the alarm while the bell or siren is sounding, enter your code number, press the COMMAND key,
and press the Select key under SILENCE. This silences the alarm but does not cancel any alarm reports
to the central station. Silencing an alarm while the bell is sounding sends an Abort report to the central
station if your system is programmed to send Abort reports.
RESETTING DETECTORS
To reset a smoke or other detector, enter the User Menu by pressing the COMMAND key until MENU? NO
YES appears in the display. Press the top row key under YES. The display shows ENTER CODE: -. Enter your
code number and press COMMAND. The keypad display now shows SENSOR RESET? Press any top row key.
TROUBLE CONDITION
When a device is in a trouble condition, the keypad tones and displays the zone or device name followed
by TRBL. Press any top row key to silence.
SYSTEM TESTING
You should test the security system periodically to ensure proper operation. You can do this through a
function in the User Menu. After entering the User Menu, press the COMMAND key until SYSTEM TEST?
displays. Press any top row key to test the system bell, battery, and communication to the central station
receiver.
ALARM SERVICE
If service is required for this system, please contact:
Company _______________________________________________________________
Address_________________________________________________________________
Telephone ______________________________________________________________
The operating instructions above should be attached to the front, or framed
and located adjacent to the panel or a Security Command keypad with an
alphanumeric display.