User`s guide

56 XR200-485 Appendix C
Frequently asked questions
This section attempts to answer questions you might have regarding
the operation of your Security Command system.
Q. If I bypass an exit delay door when I arm the system, will I get
an alarm if I come through it later?
A. You will not get an alarm from the door because it is bypassed,
but if you also walk through a motion detector or other armed door
inside the premises you will get an alarm.
Q. When I arm or disarm my Area system, I get ALL? NO YES
displayed. Does this mean all areas in the system?
A. Choosing YES arms or disarms all areas that are authorized for
your user code.
Q. How do I create a schedule that starts at 8:00 am on Monday and
ends at 5:00 PM on Friday.
A. In the days of the week display, select MON (Monday). For the
OPENING TIME?, enter 0 + 8 + 0 + 0 AM. For the CLOSING TIME?, at
the MON — : AM PM display press the Select key under MON; this
scrolls through the days of the week. Stop at the day you want the
schedule to end. Next, enter 0 + 5 + 0 + 0 PM into the FRI — : AM
PM closing time display. Press COMMAND. Press the Back Arrow key
to exit the User Menu.
This sets the opening time to 8:00 am Monday and the closing time
to 5:00 PM Friday. You can substitute any other day or time in this
example.
Q. What do I do if I want to be in the building past the scheduled closing
(arming) time?
A. If your system is programmed for closing check, the keypad emits
a steady tone prior to the system arming. During this tone, pressing
any Select key displays ENTER CODE: . Enter your user code and
press COMMAND.
The keypad now displays the enter time display — : AM PM. Enter
in the new time you want the system to arm and press COMMAND.
The time you enter may extend past midnight by pressing the AM key
after the appropriate time has been entered.